Menzer LHS 225 PRO, Перевод оригинальной инструкции по эксплуатации

Страница: 51 / 112

EN 11
ENGLISH
6.3 Changing the sanding pad
(page *16* and *17*)
With the Velcro layer on both sides, the round
sanding pad is easily removed by pulling it off the
back pad and pressing on a new, perfectly centred
sanding pad (1b.–4b.).
Attention! To ensure that the working
environment is as dust free as possible, the
suction openings must match the openings of
the driving disc.
For the best sanding result, the sanding pad
must be completely flat. Damaged pads
must be replaced before further sanding.
6.4 Replacing the driving disc
(page *18* and *19*)
To replace the driving disc first loosen/pull the
sanding pad from the driving disc (refer to 6.3
Changing the sanding pad). Now tighten the
threaded axle in the centre of the driving disc with
the supplied Allen key (1c.). Now the driving disc
can be turned and removed in the direction of
rotation of the machine by the threaded axle (2c.).
The new driving disc is simply screwed on against
the rotational direction of the machine by hand
until it stops (1d. and 2d.). Now you can refit the
sanding pad (refer to 6.3 Changing the sanding
pad).
Tightening by Allen key is not necessary.
6.5 Replacing the brush rim
(page *20* and *21*)
If the brush rim of the sanding head is worn or
damaged, it must be replaced.
To replace the brush rim, loosen/pull the abrasive
from the driving disc (6.2 Changing the abrasive).
Remove the screws that hold the brush rim, and
then the brush rim itself (1e.–3e.).
Install the new brush rim in the old position and
retighten it with the screws (4e.).
Now you can refit the abrasive (refer to 6.2 Chang -
ing the abrasive).