Menvier Security TS690, Руководство оператора

Страница: 10 / 48

Unsetting After an Alarm
If an alarm has occurred whilst the alarm system is full or part set, the display will indicate
the detection circuit that was triggered when you unset the system. Once the cause of the
alarm has been established the system must be reset, see “Resetting after an alarm” on
page 11.
Enter Your Code
Time Left > 0022
ALARM 03
17:31.02 01/01
? ? ? ?
1
2
? ? ? ? ? ? ? ?
0022
CA.03
1
2
1
2
LOUNGE DETECTOR
17:31.02 01/01
LCD Remote Starburst Remote LED Remote
1.
Enter the premises via the prescribed entry route and proceed directly to the remote
keypad. The internal sounders generate an interrupted tone. The display will show the
remaining entry time.
2.
Enter your 4 digit passcode before the entry timer expires. The internal sounders will
stop and the display will show the circuit that caused the alarm.
3.
Refer to “Resetting After an Alarm” on page 11.
�
If circuit text has been programmed then the display on the LCD and
Starburst remote keypads will alternate between the circuit number and
the circuit text at step (2).
NOTES
10