Menvier Security DC58M+, Инструкции по установке и программированию

Страница: 8 / 16

Testing
Once all the installation steps have completed,
proceed as follows:
1. Ensure that you have informed the ARC that
you will be sending test calls.
2. Connect power to the control panel.
(a) If the NVM is un-programmed or fitted
incorrectly the red LED will flash rapidly.
(b) If the DC58M+ is to be programmed using
the NETLCD/TS900 remote keypad, plug it
onto the connector labelled "TS900
REMOTE". Refer to "Programming" for
further details.
3. Send a test call by momentarily shorting the
"TEST CALL" pins together, see Figures & 3. This
will initiate a test transmission to the ARC.
+
The DC58M+ will not send a test call if
there is a parallel hand-set off hook.
4. Trigger all the relevant channels by:
(a) Setting and unsetting the control panel to
send open/close signals.
(b) Set the system and cause a full alarm to
send an intruder signal.
(c) Press any PA buttons to send a PA signal.
(d) Activate any other devices that require
testing.
5. Unplug the NETLCD/TS900 remote keypad and
secure the cover of the DC58M+ using the two
screws supplied.
6. Finally replace and secure the cover on the
control panel.
8
Installation DC58M+ Installation Instructions