Menvier Security DC58M+, Инструкции по установке и программированию

Страница: 7 / 16

5. Set the "HI/LO SECURITY" link to the appropriate
setting.
6. Secure the DC58M+ base to the control panel
base using the self-adhesive pads.
7. Refer to "Telephone Line Connections" .
Telephone Line Connections
1. Connection to the telephone network must be
made via an NTE5 master socket (Line Box).
2. Using the cable type 1/0.5mm CW1308, strip
back 5mm of the required cores and feed
through the DC58M+ cable entry, see
Figure 4.
+
Keep all telephone cables at least 5mm
away from other alarm cables.
3. CW1308 cable is available from RS
Components (Part No. 368-413). Alarm or any
other type of cable must not be used.
4. Connect the three cores to the terminal blocks
marked A and B.
5. Remove the two screws from the BT master
jack socket and remove the bottom section
from the master jack.
6. Connect the cable from A and B terminals on
the DC58M+ to the BT master jack terminals,
see Figure 4.
7. A special insertion tool will be required to
connect the cable to the master jack, this is
available from RS Components (Part No.
470-487).
8. Replace the bottom section of the master jack
socket and do up the two screws. Refer to
"Testing" (see below).
NETLCD/TS900 Keypad Connections
To convert a standard NETLCD/TS900 remote
keypad into a DC58M+ programmer the
following is required:
NETLCD
TS900REM
32 character LCD remote keypad.
NETEKI Networker Engineer's Keypad
Interface lead.
7
DC58M+ Installation Instructions Installation
To PSTN
A1
B1
B
A
Phone
Red
White
Green
Blue 5
RJ11 Connector
Terminals at Jack
Adaptor Lead 485226
Direct Connection DC58M+
Using Adaptor Lead DC58M+
2
3
4
A1
B1
B
A
Figure 4 Telephone Line Connections
Figure 5 Engineer's Keypad Connections