Menvier Security DC58M+, Инструкции по установке и программированию

Страница: 4 / 16

Connection To Telephone Network
The person responsible for connection of the
DC58M+ to a PABX system is as follows:
l
If the wiring is owned by British Telecom
PLC - British Telecom
l
If the wiring is not owned by British Telecom,
either:
(a) British Telecom
(b) The authorised maintainer
(c) A professional installer after 14 days written
notice to the authorised maintainer.
Overview
General
The DC58M+ digital communicator consists of a
single PCB fitted in a small polycarbonate case. It
is used to transfer fast format status information
from an alarm system to a dedicated Alarm
Receiving Centre (ARC) via the Public Switched
Telephone Network (PSTN). The DC58M+ also
functions as a V21/V22bis modem. The DC58M+
is required when using the up/downloading
feature on compatible Menvier control panels.
Operating Modes
The DC58M+ can be used as a plug-on
communicator, in this mode the communicator is
plugged in to the control panel using the
appropriate connections cable.
NVM Programming
All programmed data is stored in a plug-in NVM
(Non-Volatile Memory) which will be retained for
up to five years with no power present. The NVM
can be programmed by using a Menvier LCD
Remote Keypad (P/No. NETLCD/TS900.REM) and
an engineer's interface lead (P/No. NETEKI) which
will plug directly on to the DC58M+. Alternatively
the NVM can be programmed using the desktop
programmer PP5.
Your ARC will normally provide a programming
service and will supply a pre-programmed NVM
on request or alternatively fill in the programming
form at the back of this manual and return/fax it to
Menvier Security (Repairs Dept.).
Technical Specifications
Supply: 11.5V - 14V; <35mA dc (Standby);
135mA dc (Active)
The installer must ensure that power
drawn by the DC58M+ plus any
other auxiliary apparatus is within
the rating of the control panel (host)
power supply.
Low Battery: Detection threshold is at 10.8V +/-
0.2V
Modem: 300/300 Baud (V21), 2400/2400
Baud (V22bis)
Programmer: NETLCD/TS900 remote keypad &
interface lead or PP5.
Case Size: 142(w) x 82(h) x 36(d) mm.
Weight 265g
REN value: 0.0
Series Voltage Drop
The voltage drop introduce by the series
connection through the DC58M+ at a line current
of 40mA is 0.1V. When used with other apparatus
(telephone, fax etc.) the total voltage drop
@40mA MUST NOT exceed 2.0V.
4
Overview DC58M+ Installation Instructions
Plug-on Mode
NETLCD/TS900
Remote Keypad
(Programmer)
Plug-on to
Menvier control
panels
Figure 2 Operating Modes