48 |
P a g e
REMOTE TRANSMITTER OPERATING INSTRUCTIONS
TO TURN ON THE APPLIANCE:
Press the ON/OFF button. The transmitter display will show all active icons on the screen.
Select the Thermostat Mode by pressing the Thermostat Key: OFF (meaning Manual Mode),
ON (meaning normal Thermostat) or Smart (meaning Smart Mode).
In OFF (Manual Mode), the appliance will ignite and start on HI.
In ON (Normal Thermostat Mode), the appliance will only ignite if the Set Temperature is
greater than the Room Temperature.
In SMART (Smart Mode), the appliance will only ignite if the Set Temperature is greater than
the Room Temperature.
TO TURN OFF THE APPLIANCE, press the ON/OFF button.
MODE
KEY:
Pressing the MODE KEY toggles between the
various available functions: Flame Height, Fan Speed and Ac-
cent Light Dimmer.
Flame Height:
6 flame height Levels are available. While the
Flame Height Icon is displayed, pressing the Up or Down but-
ton once will increase or decrease the flame height by 1 of 6
increments. If the flame height is at Level 1 and the Down but-
ton is pressed, all burners will turn OFF. If in IPI mode, the pilot
light will also extinguish. If in Standing Pilot Mode, the pilot
light will remain ON. Note: If in SMART model, the flame height function is
not available for manual adjustment. In SMART mode, the flame height
regulates automatically.
Fan Speed Control:
The fan speed can be adjusted through six (6)
speeds and OFF. To activate this function, press the MODE Key to in-
dex to the fan control icon. Use the UP/Down Arrow Key to turn ON,
OFF or adjust the fan speed. A single “beep” will confirm reception of
the command. Once you set the desired fan control, the system will re-
member your selected fan speed until you manually change it.
Accent-Light Dimmer:
This function controls the Mendota Accent
Light functions. Pressing the UP key in this mode will TURN ON the
Accent Light and allow you to control the brightness of the Accent
Light in 6 steps. A single “beep” will confirm reception of the com-
mand. Once you set the desired light brightness, the system will re-
member your selected brightness level until you manually change it.
Secondary Burner:
This function is not available on this ML47
model. Skip or bypass this function.
