8
17) Route the component harness
and power cord alongside of
the Ethernet cable previously
routed in the controller
cableway. Connect the ends to
the controller box as shown.
18) Place the unit into the island,
and position it to the desired
depth. Ensure that the vent
holes in the support brackets
are unobstructed.
19) Locate the two mounting holes
found in the back of the left
and right support brackets
(items 13 & 14), and mark the
hole locations onto the island’s
countertop.
20) Carefully slide the unit out of
the island, exposing the
marked holes on the
countertop.
21) Drill two 5/16” holes into the
countertop using a drill bit
appropriate for the material of
the countertop.
22) Insert two concrete anchors
(item 11), into the two 5/16”
holes.
23) Slide the unit back into
position, lining up the
mounting holes in the left and
right support brackets with the
concrete anchors.
24) Fasten the unit into place
using the two 1¾” long
stainless steel screws (item
12). Do not over-tighten.
INSTALLATION STEP 4: GRILL MOUNTING
17
18-19
20-22
23-24
