Memotec NetPerformer SDM-9600, Руководство по установке оборудования

Страница: 70 / 94

SDM-9600 with SDM-9606 Blades Hardware Installation Guide
5-8 Memotec Inc.
5.5.2 System Status LEDs
The following system status LEDs are located on the front face of the SDM-9606 blade:
•
OOS
(Out Of Service; green/amber) goes on (green) when the blade is powered
on; turns amber when the card has failed in a chassis that has been powered on
•
ST
(Status, red/amber/green) indicates the current program status on the blade, as
shown in Table 5-5
•
ALM
(Alarm; red/amber/green) indicates several alarm states, including a system
alarm when a software reset occurs. See Table 5-6
•
H/S
(Hot Swap: blue), located on the right side of the blade, goes on and blinks
when the card handles are opened, indicating that the blade is
NOT READY
for
removal. The blade can be removed when this LED turns off. Refer to “Remov-
ing a Blade” on page 4-12 .
The E1/T1 port status LEDS are described on “E1/T1 Port Status LEDs” on page 5-16 .
State Interpretation
Red
Early stages of system startup, when the bootstrap program is
running
Amber
Later stages of system startup, when the boot sector is running
Note:
The exact function that is taking place can be determined
in conjunction with the
ALM LED. Refer to Table 4-1
Off
System startup complete. The application is running but no link
is up
Green
The application is running and at least one link is up (specified
by the T1/E1 PORT LEDs)
Table 5-5: ST LED states
State Interpretation
Green Hardware initialization is in progress
Amber
A Write operation to Flash memory is in progress, e.g. decom-
pressing the application during startup, saving the application
after a download
Red
A software reset has occurred
Note:
To turn the
ALM
LED off, enter the
CE
(Clear ERR/DIAG
LED) command at the console command line.
Off
No alarm has occurred on the unit since the alarms were last
cleared
Table 5-6: ALM LED states