Memotec NetPerformer SDM-9600, Руководство по установке оборудования

Страница: 71 / 94

Product Description
Memotec Inc. 5-9
5.6 Ethernet Ports
5.6.1 Ports
• 2 fully routed Ethernet IEEE 802.3 LAN interfaces
• RJ-45 10/100BaseT connectors
• Each port can be configured with 2 IP addresses
• Auto-detect speed, 10 or 100 Mbps
• Frame types: Ethernet II, IEEE 802.2, 802.3, SNAP
• Ethernet interface: Ethernet II and IEEE 802.2, 802.3
• Standards: IP RIP V1/V2 or Static, OSPF, NAT, IP Multicast IGMP V1/V2 PIM-
DM, BOOTP/DHCP Relay, DHCP client, IPX RIP and SAP, LLC2, 802.1p/q pri-
oritization and VLAN, 802.1D Spanning Tree Protocol (STP), MAC Layer
• Filter Criteria: Based on protocol, address (source, destination or SAP) or custom
filtering.
For information on connecting to the LAN hub, refer to “Connecting the LAN Hub” on
page 4-22 .
5.6.2 LAN Port Status LEDs
Two LAN status indicators are located above each Ethernet port on the SDM-9606 blade
(refer to
Table 5-5 ). These LEDs indicate the following:
•
LNK:
Indicates the LAN speed:
-
Off:
10 Mbps
-
Static green:
100 Mbps.
•
ACT:
Blinks (green) when there is activity on the corresponding LAN port (LAN
traffic transmitted or received).
5.6.3 LAN Cables
Each Ethernet LAN port has an RJ-45 female connector to attach a LAN cable. Select a
standard LAN cable with RJ-45 connectors at both ends.
NOTE:
Install a ferrite on each cable that connects to an Ethernet port: Steward ferrite
28A2029-0A0, Part No. 332-0003-000.