Memmert SLM 400, Руководство по эксплуатации

Страница: 15 / 20

set
0 I
power
fresh air
0
1
2
3
4
5
6
alarm set
°C
UM 200-800/SM 200-400, ULM/SLM 400-800 14
1. Remove a screw on the cover at the lower part of the back wall and swing up the cover
as until the opening in the back wall is clear.
2. Turn the adjusting disk (knurled disk, approx. 60 mm behind the back wall) with a tool
(e.g. screwdriver) through a small angle . ( Danger! The disk is hot! )
Turning to the left increases the control temperature.
Turning to the right decreases the control temperature.
Look at the marks above cover plate at the back
side.
3. Make only small adjustments at any one time and pause (approx. 45 min) so that the
effect of the adjustment can be noted on the digital display before further adjustments
are made.
4. If required repeat the recalibration. It is essential to close the cover again and
secure it in position after each action.
Note
After each adjustment it is essential to close the cover and secure it in position.
A tightly closing door is an essential requirement on ovens. MEMMERT-ovens ensure
perfectly tight closing of the door through a seal on the oven casing. The door seal presses
accurately against the casing seal. In continuous operation the flexible seal material may
acquire a permanent set. For proper closing of the door it may be necessary to adjust the
hinge or the locking plate.
10.1 Readjusting the door
After releasing the screw No.12 ( ATTENTION!
Screw No. 12 is secured with glue. Loosen jerky
with inner hexagon key wrench 2 mm) the door
can be adjusted by turning the eccentric 13 in the
direction of the arrow (using a screwdriver).
Tighten screw No. 12 again.
In addition the upper part No.14 of the door hinge
can be moved slightly in the direction of the arrow
after releasing the 2 screws at the top or bottom of
the door.
14
12
13
The locking plate can also be readjusted in the
direction of the arrow after releasing the screw
No.15.
Ensure that the cover is again screwed down
tightly.
15
cover plate
Adjusting disk
normal regulator