15
CARE AND MAINTENANCE
Cleaning
Wipe surfaces clean with mild dish detergent or baking soda.
For stubborn surfaces use a citrus-based degreaser and a nylon scrubbing brush.
Rinse clean with water.
Note:
While cleaning the unit, be sure to keep the area around the burner and pilot
assembly dry at all times. Do not submerge the control valve assembly. If the gas control
is submerged in water, do NOT use it. It must be replaced.
TIP:
Use high-quality automobile wax to help maintain the appearance of the heater.
Apply to exterior surfaces from the pole down. Do not apply to emitter screen or domes
Maintenance
Keep exterior surfaces clean.
Air flow must be unobstructed. Keep controls, burner and circulating air passageways
clean.
Signs of possible blockage include:
Gas odor with extreme yellow tipping of flame.
Heater does NOT reach the desired temperature.
Heater glow is excessively uneven.
Heater makes popping noises.
Note:
In a salt-air environment (such as near an ocean) corrosion occurs more quickly than
normal. Frequently check for corroded areas and repair them promptly.
Storage
Between uses or during periods of extended inactivity:
Turn control knob to "OFF".
Disconnect LP cylinder and move to a secure, well-location outdoors.
Store heater upright in an area sheltered from direct contact with inclement weather
(such as rain, sleet, hail, snow, dust and debris).
Note:
Never leave LP gas tank exposed to direct sunlight or excessive heat.
If desired, use cover (Sold Separately) to protect the heater and help prevent buildup in
air passages.
CAUTION:
Wait until heater is cool before covering.
