SwitchX®-2 18-Port QSFP FDR InfiniBand System Hardware User Manual
Rev 1.1
Mellanox Technologies
37
The following is an example of the output:
6. Run the command:
7. Compare the results of this command with the latest version for your switch posted on the
support page for your switch
. This page will need a support login and password.
3.9
Rerunning the Wizard
If you want to rerun the wizard run the following commands:
sx-43 [standalone: master] > enable
sx-43 [standalone: master] # configure terminal
sx-43 [standalone: master] (config) # show interfaces mgmt0
Interface mgmt0 state
Admin up: yes
Link up: yes
IP address: 192.168.10.43
Netmask: 255.255.255.0
Speed: 1000Mb/s (auto)
Duplex: full (auto)
Interface type: ethernet
Interface source: physical
MTU: 1500
HW address: 00:02:C9:11:2A:AE
Comment:
RX bytes:
1343502058
TX bytes:
313920869
RX packets: 17589211 TX packets: 992717
RX mcast packets:
0
TX discards:
0
RX discards: 0 TX errors: 0
RX errors: 0 TX overruns: 0
RX overruns: 0 TX carrier: 0
RX frame: 0 TX collisions: 0
TX queue len: 1000
For managed switches, confirm that the latest SW revision is installed on this device.
Use the CLI to get the currently installed revision and then go to Mellanox.com to
check the revision of the latest version.
show version
sx-43 [standalone: master] > enable
sx-43 [standalone: master]# configure terminal
sx-43 [standalone: master] (config) # configuration jump-start
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from