Basic Operation
Rev 1.1
Mellanox Technologies
14
Figure 5: Externally Managed Switch System Power and Connector Side Panels
Figure 6: System Status Indicators
The system status indicators should display as follows:
•
when the switch is plugged in, within five minutes the STATUS LED should light up
green
•
the PS1 LED for the plugged in PS unit should light up green
•
the PS2 LED for the second PS unit should light up green only if a second PS unit is
installed in the switch for redundancy and it is connected to a power source
•
if two PS units are installed and only one PS unit is connected to a power supply the PS2 LED will
be red
•
if only one PS unit is installed in the switch, the PS2 LED will be off
•
the FAN LED should light up green. If the FAN LED shows red, troubleshoot the fan
module. See “Troubleshooting” on page 51.
OK
!
!
OK
OK
!
!
OK
12C
SX6015
I2C
RST
UID
PS2
PS1
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
Power Side Panel
Connector Side Panel
These two LEDs indicate the status of the switch as assigned in Table 4
on page 15.
Power side
status LED
Connector side
status LED
Both of these LEDs show the
switch status.
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
