Mellanox Technologies Switch-IB, Руководство пользователя

Страница: 66 / 146

Installation
67 Mellanox Technologies
Figure 52: Intact Spine Signal Connectors
Step 3.
Check power connector’s integrity. Look for any damage on the power connector casing or
blades damage, or any deviations from the pass criterion shown in
Figure 53 .
Figure 53: Intact Spine Power Pin Holders
Step 4.
Start with the ejector handles fully open; that is, at 45 degrees to the front panel of the spine.
Step 5.
Holding the spine by its sides, carefully set the spine module halfway into the chassis.
Step 6.
Using only the ejector handles, slowly slide the module into the chassis until the hooks
reach the vertical bar.
Step 7.
Catch the ejector handle hooks onto the vertical bar of the chassis and push the ejector han-
dles shut (
Figure 54 ).
Do not use the fan FRU handle to insert the spine module.
Do not apply excessive force to slide in the spine module. If you feel resistance,
remove the spine and double check both the chassis and spine for any damage.