Mellanox Technologies Innova IPsec, Руководство пользователя

Страница: 18 / 68

Rev 1.8 18 Mellanox Technologies
To replace the bracket you will need the following parts:
• The new bracket of the proper height
• The 2 screws saved from the removal of the bracket
• The 2 fiber washers saved from the removal of the bracket
3.4.1 Removing the Existing Bracket
1. Remove the two screws holding the bracket in place. The bracket comes loose from the card.
2. Save the two screws and the two fiber washers.
3.4.2 Installing the New Bracket
1. Place the bracket onto the card until the screw holes line up.
2. Screw on the bracket using the screws and washers saved from the bracket removal procedure
above.
3. Make sure that the LEDs are aligned onto the bracket holes.
4. Use a torque driver to apply up to 2.9 lbs-in torque on the screws.
3.5 Card Installation Instructions
1. Open the system case.
2. Place the adapter in a standard PCI Express slot.
3. Applying even pressure at both corners of the card, insert the adapter card into the slot until it
is firmly seated. When the adapter is properly seated, the adapter port connectors are aligned
with the slot opening, and the adapter faceplate is visible against the system chassis.
Due to risk of damaging the EMI gasket, it is not recommended to replace the bracket more
than three times.
Be careful not to put stress on the LED.
Do not force the bracket onto the card. You may have to gently push the LEDs using a
small screwdriver to align the LEDs with the holes in the bracket.