MELINERA 337080 2001, Инструкции по эксплуатации и безопасности

Страница: 8 / 41

8 GB
Avoid the danger of
death from electric shock!
Before use, ensure that the mains voltage
available is the same as the required operating
voltage for the product (220–240 V∼).
Before connecting the product to the mains you
should always check the product and the mains
adapter for any damage.
Never use the product if you discover that it is
damaged in any way.
This products external flexible tube is non-
replaceable. Hence if it becomes damaged
you must dispose of the entire product.
This product does not contain any parts which
can be serviced by the user. The LEDs cannot
be replaced.
Only use the product with the supplied
mains adapter for the type (Model No.
S060G300W8D for HG05412A / HG05412C /
HG05412D, S036G300W8D for HG05412B);
all warranty claims will otherwise expire.
Never open any of the electrical parts or insert
any kind of object into them.
Protect the mains cable from sharp edges,
mechanical loads and hot surfaces.
Do not install with sharp fasteners or nails.
Always unplug the mains adapter from the
socket before installation, dismantling or
cleaning.
Never touch the product’s plug or the product
itself with wet hands.
The product must not be electrically connected
to another set of lights.
If the product is not in use for any length of
time (e.g. holidays), disconnect them from the
power supply.
If you have any questions about the product or
are unsure about any of its aspects, please seek
the advice of an electrical equipment specialist.
The product is only suited for use with the
included mains adapter (Model No.
S060G300W8D for HG05412A / HG05412C /
HG05412D, S036G300W8D for HG05412B).
Please note that the mains adapter continues to
draw a small amount of power even if the product
is turned off as long as the mains adapter is
plugged into a power outlet. To switch the prod-
uct off completely, unplug the mains adapter
from the socket.
The LEDs are not replaceable.
If the LEDs fail at the end of their lifes, the entire
product must be replaced.
Use
Note: Remove all packaging materials from the
product.
Note: The LEDs are connected in series. If one LED
is defective, up to ten LEDs may not light up.
For HG05412B:
Put the ring
5
over the top of the tree.
Insert the plug on end of the product into the
socket of the mains adapter
3
. Please screw
down the connecting nut
4
clockwise.
Insert the mains adapter
3
into the mains socket.
The light set
1
is switched on.
Press the timer button
2
to switch to the next
lighting mode. When you reach lighting mode 8,
the next press of the button switches the product
back into lighting mode 1.
The light mode is listed as below:
1. combination (combination of all lighting mode)
2. in wave (LED lighting flashing in changing
frequency)
3. sequential (LED light up alternating)
4. Slo-Glo (LED slowly light up alternating)
5. chasing / flash (LED flash alternating)
6. slow fade (LED light up and fade out slowly)
7. twinkle / flash (LED light up alternating like twinkle)
8. steady on (all LED on)
To switch the product off, disconnect the mains
adapter
3
from the socket.
Timer function
To switch on the timer function, press and hold
2 seconds the timer button
2
after the product