READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE
This fixture is intended for installation in accordance with the National Electrical Code and local regulations. To
assure full compliance with local codes and regulations, check with your local electrical inspector before
installation. To prevent electric shock, turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
IS:7784
INSTALLATION PROCEDURE FOR ELLIPSOIDAL DOWNLIGHT (A-LAMP)
CAUTION: (RISK OF FIRE)
DO NOT INSTALL INSULATION ABOVE, NOR WITHIN 3 INCHES (76mm) OF ANY PART OF
THE LUMINAIRE.
INSTRUCTION SHEET NO.
A0302
Page 1 of 3
A
COMPANY
631 Airport Road, Fall River, MA 02720
A. INSTALL MOUNTING FRAME IN CEILING USING ADJUSTABLE
MOUNTING BRACKET
(1) With MOUNTING BARS (order separately):
18” – Cat. No. 1950; 27” – Cat. No 1951).
Use rectangular slots as shown.
(3) With 1 ½” channel (by others)
Slide MOUNTING BARS or CHANNELS (by others) through slots in ADJUSTABLE MOUNTING BRACKET which will place the
bottom of the MOUNTING FRAME approximately in line with the finished ceiling line. Final adjustments may be made by means of
MOUNTING BRACKET SCREWS on inside of fixture.
FIG. 1
FIG. 3
FIG. 2
FIG. 4
(2) With ¾” channel (by others)
For wood joist construction:
TELESCOPING
MOUNTING BARS No. 7994 (order separately) may be
used to secure MOUNTING FRAME (Fig.5).
FIG. 5
For suspended ceilings:
T-Bar ANCHOR CLIPS
ACCESSORY No. 1956 (order separately) may be used
with 18” or 27” MOUNTING BARS or TELESCOPING
MOUNTING BARS for quick mounting (Fig. 6) or simply
wire MOUNTING BARS to ceiling members (Fig. 7)
MOUNTING
BAR
T-BAR ANCHOR
CLIPS
ACCESSORY
WIRE
MOUNTING
BAR
FIG. 6
FIG. 7
TELESCOPING
MOUNTING BARS
