15
Use
For normal use, simply turn the headset on and off using the POWER 3 button.
In the absence of incoming audio signal, the transmitter on the base turns off automatically after 4 minutes.
When the headphones are not in use, after switching them off, place them on the recharging base, see paragraph
"CHARGING THE BATTERIES". If the headphones are not in use for a long period, remove the batteries and unplug
the AC adaptor.
IMPORTANT
- During normal operation, the RED 10 SIGNAL LED on the base should always remain on; when it is off, it means the
audio signal at the input to the transmitter is poor or absent; then increase the volume on the TV until the LED lights up.
To adjust the listening volume, turn the wheel 7 on the headphones and NOT the volume of the TV.
-If the sound is disturbed or absent when the headphones are turned on, move closer to the base and press button 6
(AUTO TUNE) for a moment to activate the headset-base coupling which is indicated by the green LED 5 lighting up .
Alternative audio connection
If the audio device doesn't have a headphone output, or if you want the TV to continue to play the sounds from your
speakers, if the RCA audio jacks (red and white with the words "OUTPUT" on them are available on the TV), connect
the audio cable from the base to the RCA audio outputs of the device, using the appropriate cable (2 x RCA male/JACK
3.5 mm female) included in the package.
Recharging Batteries
With charged batteries, the unit can operate wireless for about 8 hours. To recharge the batteries, turn the
headphones off and store them on the base. Ensure that the charging clips 11 make contact (the green CHARGE
9 LED on the front of the base must be on). Leaving the headphones on the base , even for several days will not
cause any problems.
WARNING:
-For safety reasons, the batteries supplied are of a speci
fi
c type. Never use other types of batteries to replace them. If
necessary, get in touch with MELICONI technical assistance.
-When the headphones are not in use, turn them off to avoid draining the batteries completely and damaging them.
-The batteries must be fully charged before the
fi
rst use. An initial charge of at least 12 hours is necessary to ensure the
rechargeable batteries have an acceptable lifetime. Always make sure the power button 3 on the headphones is in
the OFF position (red LED is off) during battery recharging.
Technical Speci
fi
cations
Transmission mode: UHF FM stereo
Carrier frequencies:
CH1 = 863.51 - 863.55 Mhz
CH2 = 864.01 - 864.05 Mhz
CH3 = 864.51 - 864.55 Mhz
Power supply voltage:
Transmitter = 8 V 400 mA.
Receiver = 2.4 V (2 X rechargeable Ni-MH size AAA batteries)
Frequency response: 35 Hz. - 7.8 KHz.
TYP distortion: <1%
TYP signal/noise ratio: 78 dB.
TYP channel separation: 62 dB.
Maximum transmission distance: 100 metres (in free
fi
eld)
Listening time:> 8 hours
Cuffia Senza Fili HP Comfort 140x200 5 lingue.indd 15
Cuffia Senza Fili HP Comfort 140x200 5 lingue.indd 15
03/08/18 14:35
03/08/18 14:35
