M2i-LAN Laser-Scanner manual
HB-M2-iLAN-UDP-E.doc
page 29 of 44
MEL Mikroelektronik GmbH, Breslauer Str. 2, 85386 Eching / Germany
www.MELSensor.de
T
T
r
r
o
o
u
u
b
b
l
l
e
e
S
S
h
h
o
o
o
o
t
t
i
i
n
n
g
g
Function
First action
Second action
Remarks
Check network cable
Use other cable
Use an Ethernet switch
Use other PC
Check network card
settings, use x-link cable
and direct connection
check RS-232 prompt on
power up of scanner
Check if head is properly
connected, laser lit and
LED’s lit or blinking
Terminal Software should
be active on power up of
scanner
Check if the IP is free
Power down the scanner to
see if another device has
taken the IP
Try M2D-iVision.exe
Ping the IP
Cmd: ping xxx.xxx.xxx.xxx
When the scanner is down,
no other device should
answer the ping.
When the scanner has
power, the ping should be
successful
No LAN connection
to the PC
Check network settings of
the PC, check if network
card in the PC recognizes
other network devices
Check if Scanner and PC
are in the same network
subnet
Check Gateway IP
PC and Scanner
must
be
in the same logical network
segment
Connection to PC works,
yet several seconds of
delay in the scan profile
Connection or PC is too
slow, check if Anti-Virus
Software has effect.
Use faster PC – CPU clock
800 MHz minimum
Use 100MBit network
Use M2D-iVision for
display
Eth.-Link and 100Mbit are
lit, but no connection
Check network settings
Check cable connection
Reset switches, restart PC
could help
Slow connection
Check if your network card
is 100 MBit
Use other PC, use an
Ethernet switch
Do not use hubs
Check the RS-232
monitor prompt
When RS-232 monitor
prompt does not work:
check RS-232 cabling
Rx and Tx pins inversed?
COM port set to 115.200
Baud?
Can not flash with new
firmware
Did you start with the
batch-file?
Is the firmware file correctly
set in the batch file?
Check error messages
Did you use the correct
binary file?
Flashing over the network
Message: can not load
firmware file
Has scanner been set to
programming mode?
Power down and set
programming mode switch,
then power up again
holding the Prog switch for
a second
Make sure that you have
the correct firmware file
