14
7
Z-AXIS
X-AXIS
Y-AXIS
MACHINE REFERENCES
AXES TERMINOLOGY
CONTROL UNIT
USE
OF
THE
M
A
CHINE
NOTICE
Clean the tool’s air vents every four hours by using compressed air. Exces-
sive accumulation of powdered metal inside the motor housing may cause
electrical failures.
CAUTION
Do not reach in the area of the rotating tool. The proximity of the rotating
tool to your hand may not always be obvious.
CAUTION
Never try to reach the limit sensors while the machine is moving, it could
lead to the crushing of your hand or fingers.
CAUTION
Do not alter or misuse the tool. Any alteration or modification is a misuse
and may result in serious personal injury.
CAUTION
Disconnect the plug from the power source before you make any adjust-
ments, change accessories, or store the tool. Such preventive safety meas-
ures reduce the risk of starting the power tool accidentally.
CAUTION
Store the machine out of the reach of children and do not allow persons
unfamiliar with these instructions to operate the machine. Machines are
dangerous in the hands of untrained users.
CAUTION
If the workpiece or end mill gets jammed, immediately press the emergen-
cy stop button. Wait for all moving parts to stop and turn off the spindle
with the power switch, then free the jammed material. Do not try to do this
with the spindle turned on.
CAUTION
Do not touch the end mill or collet after use. After usage they are too hot to
be touched with bare hands.
CAUTION
Before starting any machining operation, always have the workpiece se-
curely clamped. Never attempt to hold the workpiece with your hands or
using any accessories. These tools can jam easily in the material, and can
kickback, causing loss of control resulting in serious injury.
C
ARE
OF
THE
T
OOLS
NOTICE
Properly maintain the tools you use. Check for misalignment or binding of
moving parts, breakage of parts and any other conditions that may affect
the machine’s operation. If damaged, have the machine repaired before
use. Many accidents are caused by poorly maintained machines.
NOTICE
Have your machine serviced by a qualified repair person using only identi-
cal replacement parts.
1
2
MOTORS
FAN & DUST
FILTER
LIMIT
SWITCHES
PROBE Z
HDMI
ETHERNET
POWER SUPPLY
EMERGENCY STOP
USB
X
X
Z
Z
Y
Y
2
Y
1
Y