It is CRITICAL to have the DVI-to-DVI cables connected to the CONN1-CONN1 &
CONN2-CONN2 sockets on the
MX-1004
for normal operation & firmware update. Please
have the bridge connectors linked at any time.
System Requirement and Precautions
1. The
MX-1004
provides a software control program, Quartet, which runs under Microsoft Windows
98, 2000, XP, Vista through the interface of RS-232 serial control.
2. Before you click on the icon of the software, make sure you have secured the connection between
your computer COM port and the
MX-1004
and switched on the
MX-1004
with green LED light.
3. The
MX-1004
has remote control and software control. To make sure all information shown in the
software is synchronized with those in the device, please click the update button to acquire the
latest data from the
MX-1004
after you press any key on the remote control.
Instruction of Software Connection
1. Power up the
MX-1004
and you can see both red and green LEDs on the front panel blink. Make
sure the serial port (RS-232) connection secure.
2. The first step after running the software is to automatically detect if the device responses correctly
through RS-232 port. First of all, choose the correct COM port from the Com Port selection
list . Then, click on the linkage button to open the COM port. If the specified COM
port is not available, the following error message window shows up. Please check the availability
of COM Port. After the COM port is accurately established, please click on status update
button . A warning message will show up as the figure below if the serial connection is not
successfully detected.
COM Port Not Available Device Not Ready
The possible reasons causing this failure could be:
Operation Software
Page 1
1 of 18
