DATE FORMAT DD/MM/YY
SET CURRENT 50
UPPER LIMIT 0.9990000
LOWER LIMIT 0.0000000
TEST TYPE NORMAL
MEASURED RESISTANCE, CURRENT, VOLTAGE
MEASURED RESISTANCE, CURRENT, VOLTAGE
MEASURED RESISTANCE, CURRENT, VOLTAGE
………….
MEASURED RESISTANCE, CURRENT, VOLTAGE
MEASURED RESISTANCE, CURRENT, VOLTAGE
PASS or FAIL
The Upper and Lower limits are always shown in ohms.
CLEANING
The DLRO200 may be cleaned using a damp cloth and soap solution.
OPERATION
10
ENTERING NOTES IN THE MEMO SCREEN
At the end of each test you may add comments to the test results. Instead
of pressing Enter to return to the Main Menu screen, briefly press any
alphanumeric key. You will enter a
MEMO
screen that allows you to enter
up to 160 characters of alphanumeric information concerning the test. When
you have entered all information press Enter and the measurement and
memo will be stored in memory.
If you do not wish to add notes press the Test button and a new test will be
started, or the Enter button to return to the Main Screen.
TEST RESULT STORAGE
Each test is numbered sequentially, dated and timed. The test result memory
can store a maximum of 300 tests, each being identified by its test number,
date and time. When memory is full the message “
MEMORY FULL
” will be
shown. Testing may continue but no more results will be stored. See Options
Menu – Storage for more information.
REAL TIME DOWNLOADING OF TEST DATA.
DLRO200 will output data to the RS232 port every second. The data is in
ASCII format at 9600 baud, 8 bits with 1 stop bit. Connecting an appropriately
configured PC to the RS232 port will enable data to be captured in real time.
The information output is as follows:
If the output is being monitored when the DLRO200 is switched on you will
capture the instrument type (DLRO200) and the version of firmware being
run in the instrument.
Thereafter the data will be:
TEST NUMBER 1
START DATE 21/06/02
START TIME 10:23
www.actoolsupply.com
www.actoolsupply.com
