MEGA 2400 OPERATE
5
4. If the button is not pressed, the alarm will automatically stop after 30 seconds.
M. TRIGGER THE SYSTEM
When armed, your vehicle is protected as follows:
1. Light impact will trigger the warn-away signal.
2. Heavy impacts / Doors open / Hood open / Trunk open / Turn on the ignition key will trigger the
programmed sequence.
The starter disable relay (if installed) prevents the vehicle’s starter from cranking. The siren, horn,
parking lights, and dome light will turn on to alerting of an intrusion for 30 seconds. Then it will stop
and automatic reset and re-arm. If the one of sensors or detectors still active, the alarm system will
sound a maximum of 6 times of 30 seconds cycles.
N. ANTI CAR- JACKING
Warning:
If you don't need the carjacking function in this alarm system, be sure to set carjacking
feature “OFF”. This system is default setting all carjacking “OFF” (See Alarm Feature
I
-
5
Programming).
ACTIVE ANTI CAR JACKING:
1. Press and hold the transmitter
and
buttons at the same time for 2 seconds while the
vehicle’s ignition is ON. The parking lights will turns on for 1.5 seconds to indicate the system
enters the car-jacking mode.
2. Once the system in car-jacking mode, If you are forced from the vehicle, the system will be
trigger when the door is opened and closed while the ignition is “ON”.
PASSIVE ANTI CAR- JACKING:
1.
Turn the ignition switch to “ON” position; the system enters the car-jacking mode.
2. Once the system in car-jacking mode, If you are forced from the vehicle, the system will trigger
when the door is opened and closed while the ignition is “ON”.
TRIGGER THE ANTI CAR -JACKING MODE:
a). 50 seconds after the system has been triggered. The siren will start chirping for 15 seconds.
b). During this 15 seconds period of chirping, you will be alerting to push the valet switch once to
turn off the car-jacking feature. If not, it will enter second timer carjacking.
c). 65 seconds after the system has beer triggered. The siren starts alarming and the parking light
starts flashing.
d). 90 seconds after the system has been triggered
1. The siren still alarming and the parking light flashing, and
2. The starter disable will activate to prevent the vehicle from starting.
3. It will remain active until the vehicle's battery power exhausted.
OVERRIDE THE SYSTEM TO TURN OFF ANTI CAR- JACKING:
Turn the ignition switch from OFF to ON, and within 10 seconds push valet switch, the siren will
stop and the system disarmed.
Note
: If you use password pin code to protect the vehicle security, you will need to use it to disarm
the system completely.
O. DOME LIGHT CONVENIENCE DELAY & SUPERVISION
The alarm with a unique feature that will turn on your vehicle dome light as following:
1. Upon disarming, the interior light will remain on for 30 seconds.
2. If the vehicle is intruded, the interior light will flash for the same duration as the siren.
Note:
Turn on the ignition switch or arm the alarm will turn off the dome light.
P. IGNITION CONTROL DOOR LOCK/UNLOCK
(See Alarm Feature
II
– 2
Programming)
If the vehicles door locks have been interfaced to the security system, the system will automatically
lock
the vehicle's doors when the ignition is turned “ON” and /or unlock the vehicle’s doors when
the ignition is turned “OFF”.
Q. TRUNK RELEASE (CHANNEL 3) OUTPUT
Press and hold
button on the transmitter for two seconds to remote control the
trunk release or other electric devices.
R. CHANNEL 4 TIMER CONTROL OUTPUT
(See Alarm Feature
III
– 4
Programming)
Press the transmitter
and
buttons at the same time to active Channel 4 function. Channel 4
is user-programmable timer output. You may program the built-in timer to send a ground signal for
any time duration from 1 second to 120 seconds. For instance, this timer output may be used to
turn on the headlight, power window or sunroof. (Factory defaults setting at momentary output.)
S. POWER ON MEMONRY
