Megasat HSC 7800, Быстрый старт

Страница: 12 / 19

3. Designations and connections 4. Einbau einer Festplatte
ENGLISH ENGLISH
04
• Before you install a hard disk drive (HDD), please make sure that the device is disconnected from the power supply.
• You can use up to two SATA hard drives with a max. Install each 8TB (8000GB) capacity.
• Use 3.5 „SATA hard drives to secure them in the case.
Loosen the screws on the back and sides of the housing and remove the cover.
Connect the SATA cable to the motherboard (motherboard) and the hard disk.
Connect the power cable of the SATA hard disk to the motherboard.
Attach the hard drive from the bottom of the case.
Then you can close the housing cover and screw it on again.
Step 1
Step 2
Step 3
Step 4
05
3.1 Front side
3.2 Rear side
Port Description
USB USB port for additional devices (eg mouse, keyboard)
Lights red when the device is plugged in and in standby. Lights up blue when the
device is on.
Lights red when data is being read from the hard disk or written to the hard disk.
Flickers blue when the network connection is working properly.
Port Description
VIDEO IN BNC interface for Turbo HD and analog video input.
AUDIO IN RCA connector for audio input.
LINE IN Connection for two-way audio input.
VGA DB15 connector for VGA output. Shows the local video output and the menu.
RS-485 Interface Connection for RS-485 devices.
LAN Connection to the network.
ALARM IN/OUT Connection for alarm input / output.
Power Switch for switching the device on / off.
VIDEO OUT BNC connector for video output.
AUDIO OUT RCA connector for audio output.
USB USB port for additional devices (eg mouse, keyboard)
HDMI HDMI video output.
RS-232 Connection for RS-232 devices.
eSATA Storage and expansion interface for recording or backup.
GND Grounding
Power supply 100 ~ 240V AC, 48V DC