Megalarm MEGA 3100, Руководство по эксплуатации

Страница: 6 / 12

System Disarm
Activated on the
Tilt Sensor Activated on the
Close Loop Activated on the
Shock Sensor Activated on the
Ignition Switch
Clear The Flash Icon: Press the button 3 times within 3 seconds will clear the flash icon on the LCD
screen transceiver.
SILENT DISARMING: Press the
F
button first, within 3 seconds press button to silent disarm your
security system, No chirp sound will be heard, arm confirmation will be through the motorcycles parking lights
only.
TAMPER DISARMING : If alarm triggered, upon disarm the system, siren chirp 4 times, parking light flash 3
times.
DISARMING WITH PATHWAY ILLUMINATION : Press the button once to disarm the system, the siren
will chirp once. Within 3 seconds, press
F
button. The parking light will be turns “ON” for 30 seconds to
illuminate your pathway.
AUTOMATIC RE-ARM : If this feature is selected, the security system will automatically re-arm itself 60
seconds after disarming with remote transmitter. Press the
F
button twice within 3 seconds or turns on the
ignition switch will cancel the rearm.
(See Alarm Feature I – 2 Programming)
J. DISARMING WITHOUT A TRANSMITTER
OVERRIDE THE ALARM WITHOUT PASSWORD PIN CODE: (Factory Default Setting)
The Override function may be used if the remote transmitter is lost or inoperative.
1. Turn the ignition switch to 'ON’ position. (Alarm will sound.)
2. Within 10 seconds push and release the valet switch
The alarm will stop sounding and enter the disarm mode. You can now start and operate the motorcycle
normally.
OVERRIDE THE ALARM WITH PASSWORD PIN CODE:
(See Alarm Feature III – 2 Programming)
Unlike valet switch easily found, and defeated, this security system allows the consumer to program a
password pin code. Offering a higher level of security.
1. Turn the ignition switch to 'ON’ position. (Alarm will sound.)
2. Press the Valet switch the selected number of times (1-9 presses) within 15 seconds.
(Press the Valet switch, system's siren will stop alarming, parking light will stop flashing, but the
motorcycle cannot be start and drive away until you disarm the system.)
The system should now disarm. If it does not, you may have waited too long to press the Valet switch; turn
the ignition off and on and try again.
K. VALET MODE:
(System in Disarm or Valet mode)
The valet switch allows you to temporarily bypass all alarm function, eliminating the need to hand your
transmitter to parking attendants or garage mechanics. When the system is in valet mode, all alarm function
are bypassed, however the remote panic feature and Channel 3 /4 will remain operational. To use the valet
mode, the system must first be disarmed either by using you remote transmitter, or by operating the Manual
override sequence.
Enter Valet Mode:
1. From the disarmed condition, turn the ignition to “ON” position.
2. Push and hold valet switch for 2 seconds until the LED turns on. The LED wills
remain on as long as the system is in 'valet mode'.
Exit Valet Mode:
1. Return to normal operation, turn ignition 'on'.
2. Push and hold valet switch for 2 seconds, The LED wills turns off indicate the system
are exiting the valet mode.
REMOTE VALET: (System in Disarm or Valet mode)
Press and release the
F
button three times within 3 seconds to enter / exit valet mode.
A parking light flash to confirm enter valet mode
Two parking light flashing to confirm exit valet mode.
MEGA 3100 OPERATE
6