EXPANDER GSM „”
® 2G
www.megaelektronik.com.pl
Strona 6
Personalizing your device
the software module allows you to enter personal access code, give your own name a line of input, output, and
thermometers attached to the device name. Submitted names (10 characters max) will be transmitted in
messages sent from your sms or e-mail, reports, sms and e-mail.
Adding names to put on and off.
The control panel
The device has a built-in trigger alarm, you can connect a standard motion detector (PIR) sensors P. FIRE
PROTECTION, contusions, vibration and any others that provide on its output NO or NC states of matter, or plus
the range of 3 to 40V module also has an analog input operating range from 0.6V to 27.0 V device can disarm
or arm as follows: the selected input line by a signal tone from numbers, SMS a secure access code. Arming
function device can be confirmed by SMS or email. Messages from the input lines are sent as many times as
you have been stimulated to disarm time to time disarm the device.
Thermostat
Have the following options: temperature measurement using an SMS query. Temperature reading on the
internet. Sending temperature on the e-mail address.
Turn on, off and on any given time OUT depending on the recorded temperature. Communicating with CLIP
ringtones, SMS, E-MAILS about the states exceeded or damaged sensor. Remote lock / unlock sensor
connected via SMS and internetu.Info of damaged / disconnected sensor SMS or e-mail. Thermostat mode is
available only when connected sensor CT-xx. Max 2 pcs
Remote control-Restarted
the module has four relay outputs, controlling them can be done via a text message, Internet, or using logical
functions assigned to the input or the thermostat. The outputs can be switched on, switched off permanently
or specified period of time ranging from 1s to 99999s.Funkcja output control is secured with an access code.
Each output can be controlled in different ways simultaneously.
Reports
Report feature allows you to obtain device status information such as quantity and condition of each line of
input, output, analog input voltage, supply voltage, connected battery, signal strength of GSM, the number of
sent SMS
weapons state. The software allows you to select the unit of information that interests us. Reports are sent as
text messages, e-mail at specified time or on demand
Buffer power
the task of the buffer is built-in power module backup power in case the main power failure. The module
controls the voltage of the battery pack attached, and the situation for low or too high voltage can inform
specific users by SMS, e-mail also has the function of the battery below the specified cutoff voltage, which
prevents the flat.
Event Buffer
The device can record in a minute max twelve different events and perform the functions assigned to them,
such as output, sending a text message, clip, e-mail occurs in amounts of more than twelve per minute will be
skipping.
Limiting the cost of lock
the module allows you to determine the amount of SMS sent within 24 hours. The change of these parameters
can be done using a text message or Internet over GPRS.
The "Messenger" ®.
Using "SMS ® Messenger, Messenger GSM ®"
We can remotely manage the SIM card located in the module, such as prepaid or post codes to activate the
service to add new packages, etc., be sure also to include the "Echo" by which we receive feedback messages
from GSM networks such as account balance, etc.
