5
Hot and cold settings
To change the function of the machine to either hot or cold press the HOT/COLD switch. When it is
switched to hot the set temperature will show on the LCD display. When it is switched to cold, COLD
will show on the LCD display.
Forward and reverse switch
The FWD/REV switch changes the working direction of the motor. When it is switched to forward the
motor will run forward and will show on the LCD display.
When it is switched to reverse the motor will run backwards and REVERSE will show on the LCD
display. This function is used to remove items fed in incorrectly or by mistake - please note removed
items will not be reusable.
Run and stop switch
The RUN/STOP switch enables you to start and stop the motor. When it is switched to RUN the
machine rollers will turn in the direction of the motor drive. If either the feed tray or guard are not in
place, the machine will not drive, however, by pressing the load button the rollers will operate while
the button is pressed to enable the film to be fed into the machine.
Operating instructions
Check the power voltage for the machine to ensure this meets your own supply. Plug the power cord
into the back of the machine and into your power supply. Contact your supplier if you do not have a
power cord with the machine.
Motor overload circuit breaker
If the machine should jam in a way that the motor could be affected, the circuit breaker will cut off the
power to avoid damage. Once the overload has been cleared, press the circuit breaker button and
the motor will start again. The circuit breaker button is located at the rear of the machine next to the
power switch. The button is red in colour.
Screen messages
Should the LCD display panel show the words OPN fault or CLS
fault, there may be a problem with your machine. In this instance,
turn off the power and call an engineer.
Familiarise yourself with the control panel before commencing
operation of the machine.
Turn on the power switch, the control panel
Display will light, this indicates the power is
connected
