EN
126
Guide bar
• Reverse the bar at regular intervals to prevent partial wear
• The bar rail should always be absolutely straight
• Check for wear of the bar rail Apply a ruler to the bar and the outside of a cutter If a gap is
observed between them, the rail is normal Otherwise, the bar rail is worn Such a bar needs to
be corrected or replaced
NOTE:
The table below shows all approved combinations of bar and chain For replacement only bars
and chains from the table below may be used If you use non-approved combinations it may cause
serious personal injury and damage to the machine
Pitch
Guide bar
Chain
Zoll
Length (cm)
Width (mm)
Code
Code
3/8”
35 cm
13 mm
AE14-53-509P
91S053T
STORAGE
1
Empty the fuel tank and run the engine out of fuel
2
Empty the oil tank
3
Clean the entire unit
4
Store the unit in a dry place out of the reach of children
1
Ruler
2
Gap
3
No gap
1
2
1
3
Содержание 721-341
