EN
113
Cold start
1
Put the switch to the ”I” position
2
Continuously push the primer bulb until fuel appears in the bulb
3
Pull out the choke knob The choke will close and the throttle lever will then be set in the
starting position
4
Push the front handle guard/chain brake down toward the front to activate the chain brake
5
While holding the saw securely on the ground, pull the starter handle vigorously
6
When the engine fires, press the throttle to reset the choke and pull the starter handle again
to start the engine
7
Pull up the front handle guard/chain brake toward the actual handle to release brake
Then, allow the engine to warm up by applying a slight pressure to the trigger
Warm start
1
When restarting immediately after stopping the engine Set choke in the open position
Once the choke knob has been pulled out, it will not return to the running position and
it cannot be pressed in by hand
2
When you wish to return the choke knob to the running position, press the throttle instead
3
Follow the instructions for Cold Start from point 4 onwards
Trigger lock-out
Throttle
Содержание 721-341
