EN
36
FITTING THE DUST EXTRACTION
ADAPTER
The dust extraction adapter can be attached
with the hose connection to the front or back.
If the guide bushing adapter is attached it
may need to be turned 180° so that the guide
bushing adapter does not touch the release
lever. The chip guard must be removed first
when fitting the chip guard to the front.
• Fasten the dust extraction adapter on the
base plate with 2 finger grip screws.
CONNECTION OF DUST
EXTRACTION EQUIPMENT
WARNING!
Only use dust extractors that are suitable for
the actual material. A special dust extractor
must be used if the dust is dry and especially
hazardous to health, or carcinogenic.
1. Put a dust extraction hose with a
diameter of 35 mm in the connected dust
extraction adapter.
2. Connect the other end of the hose to a
vacuum cleaner.
FITTING THE CHIP GUARD
• Put the chip guard from the front in the
guide so that it fits in place. To remove the
guard, grip the sides and pull forward.
USE
BEFORE USE
Adjusting the speed
The required speed is adjusted with the knob.
The speed can be adjusted while the motor is
running.
1–2 = Low speed
3–4 = Medium speed
5–6 = High speed
The best speed to use depends on the material
and working conditions. Practise by trial and
error.
After working at low speed for some time the
product should be run freely at maximum
speed for about 3 minutes to cool down.
STARTING/STOPPING
NOTE:
Adjust the cutting depth according to the
instructions before starting/switching off the
product.
1. Start the product by pressing the power
switch and holding it in. For continuous
operation, press the lock button when the
power switch is pressed.
2. Switch off the product by releasing
the power switch. During continuous
operation, switch off the product by
tapping the power switch and then
releasing it.
Electronic speed control
The electronic speed control keeps the speed
constant, with or without load, which ensures
smooth machining.
SOFT START
The electronic soft start function limits the
torque when starting, which increases the life
span of the motor.
ADJUSTING THE CUTTING DEPTH
WARNING!
Switch off the product, pull out the plug and
wait until all moving parts have completely
stopped before cleaning, adjusting,
maintenance and/or replacing accessories.
1. Put the product on the workpiece with
router bit in place.
