Meec tools 011638, Руководство по эксплуатации

Страница: 28 / 30

EN
28
• Check that are no electrical cables, gas
and/or water pipes in the work area.
SUPPORT HANDLE
IMPORTANT:
The support handle can be put in the required
position and makes it easier to hold the
product when working. ALWAYS use the
support handle.
The support handle can be turned 360°
vertically and angled forward and back. Undo
the lock nut for the support handle, move the
handle to the required position, and tighten
the lock nut.
1. Lock nut
2. Support handle
FIG. 2
BITS
Clean the bit shaft before fitting, and apply a
little grease.
1. Bits
2. Bit holder
FIG. 3
1. Press in the bit holder.
2. Put the bit in the bit holder.
3. Release the battery holder to lock the bit
and check that it is firmly in place.
4. Follow the instructions in the reverse order
to remove bits.
HOW TO USE
IMPORTANT:
Hold the product firmly with both hands –
risk of electric shock if the bit comes into
contact with live cables.
WARNING!
The actual vibration and noise level when
using tools may differ from the specified
maximum value, depending on how the
tool is used and the material. It is therefore
necessary to determine which safety
precautions are required to protect the user,
based on an estimate of exposure in actual
operating conditions (taking into account all
stages of the work cycle, e.g. the time when
the tool is switched off and when it is idling,
in addition to the start-up time).
DESCRIPTION
1. Support handle
2. Crank arm cover
3. Power switch
4. Motor casing
5. Lock nut
FIG. 1
The product is supplied with the following
accessories:
• Flat chisel (18x320 mm)
• Pointed chisel (18x320 mm)
• Support handle
USE
WARNING!
• Check that the mains voltage
corresponds to the rated voltage on the
type plate.
• Switch off the product, pull out the plug
and wait until all moving parts have
completely stopped before adjusting,
replacing parts, cleaning and/or carrying
out maintenance.