4.5 Memory
4.5.1 Memory Recall
4.5.2 Clear Memory
When the device is power off or stand-by press MEMORY button
②
it will display the
average value of the last three measurement results. You can recall the measurement
by pressing MEMORY button
②
or
DOWN button
⑤
. If the measurement result is displayed together with flashed pulse
icon it means irregular heartbeat is detected during that measurement.
If the voice guided function is ON the device will read the measurement result via voice.
You can exit from memory recall by pressing ON/OFF button
①
at any time.
Before clear the memory please confirm that the stored measurement results are
useless to you. We suggest you writing down your measurement results as blood
pressure diary to provide necessary information for your doctor.
If you decide to clear all stored memory you can press the MEMORY button
②
to enter
to memory status when the device is power off or stand-by. Then hold the MEMORY
button
②
for 3 seconds till “00” displayed.
Please note: you can’t delete individual stored measurement result.
7
4.4 Take a Measurement
Please follow the below steps to take a blood pressure measurement after preparation is
finished. (List blood pressure is mmHg for example)
1) Press ON/OFF button
①
the device will turn on and LCD display will show all
segments for 1 second. Then “0” will flash and the cuff will start to inflate
automatically. If the voice guided function is ON the device will provide voice instructions.
2) When the correct pressure is reached, the pumping stops and the pressure falls
gradually. The pulse Icon will flash when the pulse signal is detected.
3) After measurement is finished the cuff will deflation automatically then the
systolic/diastolic blood pressure, pulse rate and blood pressure unit will be displayed and
stored. If the voice guided function is ON the device will read the measurement result via
voice. If irregular heartbeat is detected the pulse icon will flash.
●
When the systolic pressure ≥140 mmHg (18.7 kPa) and/or diastolic
pressure ≥90 mmHg (12 kPa) the data displayed on LCD will flash that
reminding your blood pressure is abnormal. If the voice guided function is
ON the device will remind you via voice.
●
If you feel any uncomfortable such as the cuff is inflated for a long time it may be a risk.
You must stop the measurement by pressing ON/OFF button
①
.
●
If the cuff pressure is over 300 mmHg (40 kPa) without deflation automatically please
remove the upper arm cuff.
●
Repeat measurements will cause the upper congestion and then affect the measurement
result. Improvement method: remove the cuff and relax for 2~3 minutes then take a
measurement again.
The values measured by yourself in home may be lower than those measured in hospital
because you feel more relax and comfortable in home. The daily blood pressure
measurement is very important to manage your blood pressure. But even you take blood
pressure measurements in home the following situations may cause the blood pressure
values changing:
- In a hour after dining;
- After drinking wine, coffee or tea;
- After smoking, exercise or bathing;
- Nervous or emotional instability;
- Talking or movement during measurements;
- The ambient temperature is changed rapidly;
- Continuous measurement for long time
Please follow the doctor’s directions instead of diagnose by yourself based
on the measurement result.
●
Always measure on the same position.
●
The blood pressure is affected by many factors.
6
Warning
Warning
