3.2 System Setting
3.3 User Choice
1) Hold SET button
③
for approx. 3 seconds when the device is switched off, the year
number flashes on the display.
2) You can set the year by pressing MEMORY button
②
or DOWN button
⑤
.
3) To confirm and the year by pressing the SET button
③
.
4) Repeat step 1) to 3) to set the month, day, hour and minute.
5) After setting the minute is finished press SET button
③
to confirm and then enter to
set the blood pressure unit.
6) Press MEMORY button
②
or DOWN button
⑤
to shift between mmHg and kPa
then confirm it by pressing SET button
③
. After that you can enter to voice setting.
7) Press MEMORY button
②
or DOWN button
⑤
to shift between ON and OF (ON
means voice guided is switched on, OF means it is switched off) and confirm it by
pressing SE --T button
③
. Then switch off the device.
8) Press SET button
③
you can review the current date, time and user.
You can see the current user by pressing User button
④
then shift the user by
pressing this button again. After that you can save this user as current user by
pressing ON/OFF button
①
to switch off the device.
4
4.1 Important Notes
4.2 Applying the Cuff
4.3 Correct Body Posture during Measurement
To ensure the measurement accuracy please follows the below suggestions:
●
Do not eat, drink, smoke or exercise before measurement.
●
Take the measurement after urination and defecation.
●
Sit down for at least 10 minutes before measurement and relax.
●
Take the measurement in a quiet environment. Do not move or talk when take the
measurement.
●
Leave a small break of 2~3 minutes between two measurements.
●
Try to take your measurement at the same time in every day.
●
Support your arm in a relaxed position and ensure that the cuff is at the same
height as your heart (Figure 3).
●
Relax, do not move and do not tense your arm muscles. Breathe normally and do
not talk.
1) Connect the cuff to the device by inserting the cuff connector into the cuff socket
⑧
.
2) Remove the close-fitting garments from the upper arm. The shirt sleeves should not
be rolled up if they are laid flat.
3) Place the cuff over your left upper arm with your left palm facing upward and leaving a
clearance of approximately 2~3cm between the cuff and the elbow. The air hose outlet
must lie over the artery which runs down the inner side of the arm (Figure 3).
4) Fit the cuff closely, but not too tight.
5) If you can not apply the cuff on the left upper arm, you also can take a measurement
using the right upper arm position.
Figure 3
5
4. Take a Blood Pressure Measurement
