13
BED ASSEMBLY
Connecting the Two Frames:
See Figure 2
1. Place the Head Spring Section on its side to your left with the center mounting hooks
to your right.
2. Place the Foot Spring Section on its side to your right with the head frame pull tube at
the top of the assembly and the center mounting rivets facing to the left.
3. The crank handles and/or motors should be at your right.
4. The head and foot springs should now be on their sides at approximately a 90° angle
to one another.
5. Hook the
bottom
head spring center mounting latches to the
bottom
foot spring center
mounting rivets. (see Figure 2a)
6. Hook the
top
head spring center mounting latches to the
top
foot spring center
mounting rivets. (It may be necessary to lift slightly on the head spring or foot spring to
secure the mounting latches and rivets.)
7. After head and foot springs are connected, slowly open the springs into a horizontal
(straight) position while still on their sides. Make sure the hooks engage the rivets at
all times.
8. Lay the bed flat with the springs facing up.
Head Spring Section
Foot Spring Section
Figure 2: Connecting the head and foot frames