Proceed as follows:
Unlock the mobile rack by pressing the release lever.
Pull the mobile rack out of the slot.
Place the mobile rack onto a fi rm surface with the open side facing upwards. If
necessary, use a soft surface to minimise any knocks or collisions. The handle must
be facing in your direction.
Pull the hard drive decoupler out of the mobile rack.
The upper surface of the hard drive should be facing upwards
with the contacts located in the bottom right.
Now insert the hard drive at an angle into one side of the
mobile rack.
Ensure that both small hooks on the mobile rack slide into the
screw holes on the hard drive. Then carefully allow the hard drive to slide
completely into the mobile rack.
Press the hard drive decoupler back into the mobile rack.
Ensure that both metal pins slide into the screw holes on the
hard drive.
Carefully slide the mobile rack into the slot until it clicks into place.
Lock the mobile rack in place by pressing on the handle until it audibly clicks into
place. The hard drive will be recognised and can now be used.
Installing a 2.5” SSD drive in a 2.5”/3.5” mobile rack
When installing an SSD drive, follow the fi rst four steps in the previous instructions and
then proceed as follows:
The upper surface of the hard drive should be facing upwards with the contacts
located in the bottom right.
Now insert the right side of the hard drive into the mobile rack.
Hard drive
29
8866 EN ALDI AUS Content MSN 2006 3048 RC1.indb 29
8866 EN ALDI AUS Content MSN 2006 3048 RC1.indb 29
11.08.2016 11:34:48
11.08.2016 11:34:48
