MD 9028 BDA GB 27.08.2002 9:42 Uhr Seite 5
CONTROLS AND CONNECTIONS
Video Receiver
2.4 GHz
Video
Antenna
TV Output
Connector
A/V Jacks
Power Supply
Jack
2.4 GHz Channel
Switch
(on bottom)
TV Channel
Switch
(on bottom)
ON-OFF
Switch
(on side)
SETTING UP THE CAMERA/VIDEO SENDER, POWER SUPPLY
Referring to the diagrams below and on the next page:
1. Attach the camera to a wall using the screws provided.
2. If you install the camera outdoors, make a small hole in your
exterior wall and pass the low voltage power jack through it.
3. Plug the power supply jack into the socket on the adapter cable
from the camera.
4. Plug the power supply into any 230 V/~50 Hz AC outlet.
5. Set the channel switch on the camera to any letter A, B, C, or D
6. Adjust the antenna if necessary to aim it in the direction of the
TV or monitor that you will view the camera on.
