Before replacing the way measurement system for the lateral shifting, the table top has to be taken off. For
further help please see
Chapter III „Removing the Table Top“.
Also remove the crusting protector and loosen the expansion bellows, as stated in
Chapter IV “Removing the
Crusting protector“
and
Chapter VI „ Loosening the expansion bellows“.
Additionally put off the column cover. For further help, please
see
Chapter V „ Removing the Column Cover“.
Do as follows:
Before removing the way measurement system, the respecti-
ve driving pin has to be loosened from the cylinder.
Later on, the position of the driving pin on the cylinder will
indicate the preset „Zero Point Adjustment“. It is absolutely
necessary to place the driving pin correctly in order to gua-
rantee the right position of the „zero point adjustment“.
Therefore, the right position of the driving pin should be
marked in advance by drawing the contour with a pencil.
The tube clamp, which fixes the driving pin to the cylinder,
can now be opened.
Loosen the screws of the way measurement system with the
the holder at the piston rod of the cylinder.
The system can be easily removed.
X. Replacement of the Way Measurement System
(Lateral Shifting)
medifa GmbH & Co. KG – Industriestraße 5 – D-57413 Finnentrop, Tel.: +49 (0) 2721-7177-0 – Fax: +49 (0) 2721-7177-77
21
