medemagroup Mini Crosser X1 HD, Руководство по обслуживанию

Страница: 39 / 108

Service manual 1533-2003-S 39 of 108 Version 1.0.2/2020
Medema Production A/S
Area Component Check and remedy
Braking distance 10 km/h - 2,0 m (10)
13 km/h - 2,8 m (10)
15 km/h - 3,5 m (10)
The figures in brackets indicate the
normal braking parameter when the
scooter leaves the factory. It can be
changed with the programming unit
(forward deceleration). See below for
more information. Please note that the
braking distance must not be longer
than specified in order to comply with
official requirements.
Steering column Play/wear Check the following:
- Universal joint
- Pins in steering shaft/front fork
- That the aluminium bottom section of
the steering column is firmly secured to
the steering shaft. (*)
Wear/rust on the bearings in the steer-
ing column. Top support bearing. The
bearings in the head tube are protected
by seal rings. If the front fork is a bit
stiff, the seal rings can be lubricated
with a little grease.
(*) On models with an 8 mm bolt going
into the steering shaft from the alu-
minium bottom section of the steering
column. The bolt can work loose if the
steering column is twisted/knocked
hard. This can be remedied by drilling a
hole for a split pin between the steering
shaft and the aluminium section. Con-
tact Mini Crosser A/S.
Cables Check that the cables cannot become
trapped or be subjected to strain when
the handlebars are turned or the steer-
ing column is folded down.
Gas spring Check:
That the gas spring locks the steering
column securely.
Check that there is no play in the
release lever and the bolts/bushes
securing the gas spring.
Key switch / charging
socket
Check that the key switch does not
wobble.
Clean with a damp cloth or compressed
air if dirty. If the contacts are corrod-
ed, clean them with contact spray or
replace the charging sockets.
Chassis / seat /
covers
Footplate Check the plastic rivets securing the
mat. Fit new ones if necessary.