MED Associates PHM-104A, Руководство пользователя, Страница: 11 / 22

MED ASSOCIATES, INC. PHM-104A HIGH/LOW SPEED PRECISION PUMP
Hardware Setup
1.
Place the infusion solution in a reservoir.
2.
Connect a section of tubing of the required length to the Input port on the manifold, shown in
Figure 2.2 – Manifold End of the PHM-104A, using a female luer connector.
3.
Submerge the other end of the section of tubing in the infusion solution.
4.
Connect a section of tubing of the required length to the Output port on the manifold, shown in
Figure 2.2 – Manifold End of the PHM-104A, using a female luer connector.
5.
Be sure that any air bubbles are evacuated from the system prior to running the pump. Air in the
syringe or tubing may cause inaccurate infusions.
6.
Connect the other end of this section of tubing to the swivel.
Figure 3.3 - Hardware Setup Diagram
- 7 -
DOC-187 Rev. 1.6 Copyright © 2019
Med Associates, Inc.