mectron Silverlight, Руководство по использованию и обслуживанию, Страница: 15 / 26

15
silverlight - manual of use and maintenance
06.5 Safety protection
In the event of extreme heady duty use, with long and repeated exposure cycles, a thermal protection
device is triggered automatically.
An acoustic signal (three beeps) will be heard.
This protection device will temporarily prevent use of the lamp for a few minutes.
06.6 Red battery LED on the recharging unit illuminated
The red battery LED (check) on the recharging unit indicates the following:
1. Battery failed (see point 05.4).
2. Contacts on the recharging unit short-circuited.
In the second case, to restore correct functioning of the charging unit:
1. Disconnect the charging unit from the power supply. All LEDs extinguished
2. Eliminate the cause of the short circuit
3. Re-connect the charging unit to the power supply - green power LED on.
07.0 Cleaning, disinfection, sterilization
07.1 Cleaning and disinfection of the casing of the recharging unit
�
DANGER: Switch off the recharging unit.
Before carrying out any cleaning and disinfection, disconnect the recharging unit from the main power
supply.
�
DANGER: The casing of the recharging unit is not protected against the entry of liquids.
�
DANGER: Do not spray liquids directly onto its surface or onto the electrical contacts of the
recharging unit.
�
DANGER: The recharging unit must not be sterilized.
Proceed as follows after each treatment:
1
Remove the handpiece from the recharging unit.
2 Clean and disinfect the surface of the casing using a cloth moistened with a solution of mild
detergent/disinfectant having a neutral pH (pH = 7).
Follow carefully the instructions provided by the manufacturer of the disinfectant solution.
Allow the disinfectant solution to air dry before reconnecting the recharging unit to the power supply.
Above all, make sure that the electric contacts are completely dry.
NOTE: Water-based disinfectants with a neutral pH are strongly recommended. Some alcohol-based
disinfectant solutions may be harmful and cause damage to plastic materials.
07.2 Cleaning and disinfecting the Silverlight handpiece
�
DANGER: The handpiece is not protected against the penetration of liquids.
�
DANGER: Do not spray liquids directly onto its surface or onto the electric contacts.