3
2
1
+ 90°
electromechanical operator for sliding gates
Nyota 115 evo
21
GUIDANCE FOR PROPER USE
(for the end user)
GUIDANCE FOR PROPER USE
• Transit across the gate is allowed only if motor is stopped; stand at safe distance during opening and/or closing cycles of the gate.
• Do not touch any components of the system while the operator is working.
• Do not allow children and/or people to stand in the proximity of a working operator.
• Keep all the accessories able to turn on the operator (transmitters, proximity readers, key-switches, etc.) out of the reach of the children.
• Do not run the system in case of anomalies.
DISPOSAL OF MATERIAL
: dispose properly of the packaging materials such as cardboard, nylon, polystyrene etc. through specializing
companies (after veri cation of the regulations in force at the place of installation in the eld of waste disposal). Disposal of electrical and
electronic materials: to remove and dispose through specializing companies, as per Directive 2012/19/UE. Disposal of substances
hazardous for the environment is prohibited.
WARNINGS
For optimum performance of system over time according to safety regulations, it is necessary to perform proper maintenance and
monitoring of the entire installation: the automation, the electronic equipment and the cables connected to these. The entire installation
must be carried out by quali ed technical personnel. Operator: maintenance inspection at least every 6 months, while for the electronic
equipment and safety systems an inspection at least once every month is required. The manufacturer, Meccanica Fadini snc, is not
responsible for non-observance of good installation practice and incorrect maintenance of the installation.
Advice for the end user
:
• clear the site of materials that may have deposited in the equipment and hinder its correct functioning (such as rests of insects, foliage,
stones, etc.); before carrying out this operation, switch off voltage supply;
• clean regularly the equipment by using a damp cloth. Do not use ammable substances such as alcohol, solvents or benzene: these
substances may cause explosions and/or damage the system.
MAINTENANCE
Pic. 15
This manual operation is to be carried out in case of power failure or faults detected with the systems.
Use the coded key to unlock the handle, then rotate it beyond 90° to disengage the pinion; open the gate by hand. To lock back the gate
carry out the same operations in a reverse sequence, then slide the gate on to the pinion until the locking device is re-engaged.
LOCKING AND UNLOCKING THE GEARED MOTOR
