Page 8 Version 2
Check throwing cycle next:
(a)
Check that the bolt holding the arm to its clamp block is tight.
(b)
Check arm for chunks missing from the black arm rubber or any other physical
damage to the arm. If damage has occurred the black arm rubber should be replaced.
(c)
Check for damage to the throwing plate, in case it has been dented, bent or burred.
Ensure that no screw heads protrude and that there are no other obstructions to the clay’s
path.
(d)
Check the height of the arm over the plate across its whole surface to ensure that the
clay fits under the black rubber throwing arm strip with about 1/16” clearance. Any more
than this clearance can cause the arm to break the clay by riding over it. Adjust by raising
or lowering the throwing plate with 4- ½” nuts on the plates adjustment bolts.
2. Machine throws clays but:
(a)
The clay barely flies off throwing plate:
Check the height of the arm over the plate across its whole surface to ensure that
the clay fits under the black rubber throwing arm strip with about 1/16” clearance.
Any more than this clearance can cause the arm to break the clay by riding over it.
Adjust by raising or lowering the throwing plate with 4- ½” nuts on the plates
adjustment bolts.
https://www.youtube.com/watch?v=qPnQpIMGT7E
https://www.youtube.com/watch?v=IDGtb62lXj4
The arm might be bent down or the throwing plate bent up, squeezing the clay
between them, the arm or plate should be replaced or straightened.
(b)
The clay goes no distance (even though the main spring is wound up tight).
The arm is probably bent upwards causing clay to go under it at its tip. This will
also cause clays to break, the solution, is to straighten or replace the arm.
(c)
The clays are inconsistent in direction.
This could be caused by buildup of debris on the throwing plate; dirt, leaves,
pieces of broken clay.
This is could also be caused by the front rail not moving freely. Light oil or a
mechanical adjust if not free.
(d)
If the machine is a “Midi” or Mini”, the arm timing could have slipped.
