Page 4 Version 2
Step 9
– Adjust the machines tilt by loosening the two top ½” nuts on the base of
the machine. There is one at the front and one at the rear of the machines. Tilt
the machine to the desired angle and then retighten both nuts. This adjustment
can be done with a
¾” wrench.
Step 10 -
Carefully load carousel with clays, removing any clays that show signs
of damage. Load clays as evenly as possible and do not over load.
Step 11
– Your machine is now loaded and ready to fire. Make sure that the
machine is pointed in a safe direction.
Step 12
– Standing at arm’s length behind the machine, press the
ARM/OFF/DISARM toggle switch to ARM. The machine will load a clay and
come to the armed position and is now ready to fire and must be treated with
extreme caution
.
Step 13
– To check for clay flight and direction, fire the trap using the
ON/OFF/DISARM toggle switch exactly as before, and press and release the
DISARM toggle. This will fire one clay and will not rearm itself. Note
– holding
the disarm toggle will continually fire clay targets. Please use caution!
LOOSEN/TIGHTEN THIS
NUT BOTH SIDES
KEEP THIS NUT SNUG AT
ALL TIMES!!!
