800-797-4632 . mecoutdoors.com
8
Step 6:
Using (2) 7/16” wrenches tighten the forward
linkage bolt assembly.
IMPORTANT!
Only tighten the forward linkage
bolt nut enough to bring all of the parts
together. The link straps must move freely up
and down. Using a 5/32” hex wrench tighten
the cam in the approximate position like it was
on your handle. You may have to adjust the
position when you begin reloading.
Step 5:
On the left side of the reloader add 1/4”
spacing washer, link strap, cam plate and
forward linkage bolt nut.
MEC AUTO-MATE ASSEMBLY MANUAL
FOR 9000G, 9000GN AND 8567 GRABBER SERIES
11
Section 3
.
STEP 4
ON RIGHT SIDE OF LOADER
ASSEMBLE THE FORWARD LINK
BOLT, LINK STRAP, AND SPACING
WASHER AS SHOWN.
STEP 5
ON LEFT SIDE OF LOADER ADD ¼”
SPACING WASHER, LINK STRAP,
CAM PLATE AND FORWARD LINKAGE
BOLT NUT.
IMPORTANT! MAKE SURE THE
THREADED HOLE IN THE LINK STRAP
IS AWAY FROM THE LOADER.
STEP 6
WITH (2) 7/16” END WRENCHES
TIGHTEN THE FORWARD LINKAGE
BOLT ASSEMBLY.
IMPORTANT! ONLY TIGHTEN THE
FORWARD LINKAGE BOLT NUT
ENOUGH TO BRING ALL OF THE
PARTS TOGETHER. THE LINK
STRAPS MUST MOVE FREELY UP
AND DOWN.
Step 7:
Re-attach the indexing actuating bracket. If
you also have the large capacity primer feed,
reattach the actuator arm at this time.
Step 8:
Add the rear link bolt and tighten using (2)
7/16” wrenches.
IMPORTANT!
Only tighten the rear linkage bolt
enough to bring all of the parts together.
12
STEP 7
RE-ATTACH THE INDEXING
ACTUATION BRACKET.
STEP 8
ADD THE REAR LINK BOLT NUT AND
TIGHTEN.
IMPORTANT! ONLY TIGHTEN THE
REAR LINKAGE BOLT NUT ENOUGH
TO BRING ALL OF THE PARTS
TOGETHER.
STEP 9
MOVE THE DROP TUBE HOLDER
ASSEMBLY BACK INTO POSITION.
12
STEP 7
RE-ATTACH THE INDEXING
ACTUATION BRACKET.
STEP 8
ADD THE REAR LINK BOLT NUT AND
TIGHTEN.
IMPORTANT! ONLY TIGHTEN THE
REAR LINKAGE BOLT NUT ENOUGH
TO BRING ALL OF THE PARTS
TOGETHER.
STEP 9
MOVE THE DROP TUBE HOLDER
ASSEMBLY BACK INTO POSITION.
