800-797-4632 . mecoutdoors.com
12
AUTO-MATE ASSEMBLY
MEC AUTO-MATE ASSEMBLY MANUAL
FOR 9000G, 9000GN AND 8567 GRABBER SERIES
Step 1:
Slide your reloader into postion on the top
of the drive base. Secure the left side of the
reloader to the drive base with the provided
thumb screws.
Step 2:
Loosen the (2) thumb screws and push the
right side. Hold down the clamping strip to
the left until it rests against the reloader base.
Secure the clamping strip tightly with the
provided thumb screws. Tighten with an allen
screw using 5/32” hex wrench.
Step 3:
With a 1/2” end wrench, remove the ny-lock
nut from the actuation wheel pivot point.
Attach the bottom end of the pull rod and
tighten the lock nut.
16
Auto-Mate Assembly
STEP 1
SLIDE YOUR AUTO-MATE INTO
POSITION ON THE TOP OF THE
DRIVE BASE.
WITH THE PROVIDED THUMB
SCREWS, SECURE THE LEFT SIDE
OF THE LOADER TO THE DRIVE
BASE.
STEP 3
WITH A ½” END WRENCH, REMOVE
THE NY-LOCK NUT FROM THE
ACTUATION WHEEL PIVOT POINT.
ATTACH THE BOTTOM END OF THE
PULL ROD AND TIGHTEN THE LOCK
NUT.
STEP 2
PUSH THE RIGHT SIDE HOLD DOWN
CLAMPING STRIP TO THE LEFT UNTIL
IT RESTS AGAINST THE LOADER
BASE.
SECURE CLAMPING STRIP TIGHTLY
WITH THE PROVIDED THUMB
SCREWS.
16
Auto-Mate Assembly
STEP 1
SLIDE YOUR AUTO-MATE INTO
POSITION ON THE TOP OF THE
DRIVE BASE.
WITH THE PROVIDED THUMB
SCREWS, SECURE THE LEFT SIDE
OF THE LOADER TO THE DRIVE
BASE.
STEP 3
WITH A ½” END WRENCH, REMOVE
THE NY-LOCK NUT FROM THE
ACTUATION WHEEL PIVOT POINT.
ATTACH THE BOTTOM END OF THE
PULL ROD AND TIGHTEN THE LOCK
NUT.
STEP 2
PUSH THE RIGHT SIDE HOLD DOWN
CLAMPING STRIP TO THE LEFT UNTIL
IT RESTS AGAINST THE LOADER
BASE.
SECURE CLAMPING STRIP TIGHTLY
WITH THE PROVIDED THUMB
SCREWS.
16
Auto-Mate Assembly
STEP 1
SLIDE YOUR AUTO-MATE INTO
POSITION ON THE TOP OF THE
DRIVE BASE.
WITH THE PROVIDED THUMB
SCREWS, SECURE THE LEFT SIDE
OF THE LOADER TO THE DRIVE
BASE.
STEP 3
WITH A ½” END WRENCH, REMOVE
THE NY-LOCK NUT FROM THE
ACTUATION WHEEL PIVOT POINT.
ATTACH THE BOTTOM END OF THE
PULL ROD AND TIGHTEN THE LOCK
NUT.
STEP 2
PUSH THE RIGHT SIDE HOLD DOWN
CLAMPING STRIP TO THE LEFT UNTIL
IT RESTS AGAINST THE LOADER
BASE.
SECURE CLAMPING STRIP TIGHTLY
WITH THE PROVIDED THUMB
SCREWS.
