Page 31
MMAE16 - Operator’s Manual
January 2022
Secton 9 - Transport and Lftng Instructons
Lifting the Machine with a Forklift
Be sure the controls and component trays are secure. Remove all loose
items on the machine.
Fully lower the platform. The platform must remain lowered during all
loading and transport procedures.
Only qualified forklift operators should lift the machine with a forklift.
Insert forks into the fork pockets as shown in the image. Position the forklift
forks in position as the figure above.
•
ART_5803B
Insert forks completely into the fork pockets.
Raise the machine 6 in (15 cm) and then tilt the forks back slightly to keep the machine secure.
Be sure the machine is level when lowering the forks.
Lifting Instructions
Only qualified riggers should rig and lift the machine.
Be sure the crane capacity, loading surfaces and straps or lines are
sufficient to withstand the machine weight. See the serial plate for the
machine weight.
Fully lower the mast. Remove all loose items on the machine.
Attach the rigging only to the designated lifting points (tie-down points) on the
machine. There are four lifting points (tie-down points) on the chassis.
Adjust the rigging to prevent damage to the machine and to keep the machine
level.
•
•
ART_5803C
Storage procedure
The machine should be stored as below if it should not be used for long period.
The environment temperature should be within -4°F (-20°C) ~ 122°F (50°C)
The environment humidity ≤ 90%.
The machine should be stored indoor and the ground should be firm and level. If stored outdoor
the machine should be covered to protect from water and dust.
Ensure the machine has been cleaned and functional, before placed in storage. Repair or
maintain it if necessary.
Place the machine in a suitable position so that driving or moving the machines is convenient.
Every 60 days the battery must be charged to full capacity.
The machine can not be used to service until it has been inspected and maintained according to the
daily check procedure.
•
•
1.
2.
3.
4.
