Platform/Jib/Riser Functions Control Lever
The Platform/Jib/Riser Functions control lever controls the Platform Rotate, Jib Lift/
Lower functions, and Riser Boom Lift/Lower functions. The control lever is fully
proportional for platform rotate and jib functions.
These functions are enabled by pressing the trigger on the front of the control lever.
Test Operation
To test the Jib Lift/Lower function:
• Squeeze the enable trigger, then pull the control lever back to raise the jib.
• Squeeze the enable trigger, then push the control lever forward to lower the
jib.
To test the Platform Rotate function:
• Squeeze the enable trigger, then push the control lever left to turn the
platform clockwise.
• Squeeze the enable trigger, then push the control lever right to turn the
platform counter clockwise.
Shutdown Procedure
• When finished with the machine, place the platform in the stowed position.
• Park the machine on a level surface.
• Carefully exit the platform using a constant three (3) point dismount/grip.
• Turn the Selector Key Switch to the OFF position and remove the key to
prevent unauthorized use. Always put the switch in OFF position when
leaving the machine at the end of the work day.
ART_4733
ART_4734
Operation Instruction
To test the Riser Lift/Lower Function
• Squeeze the enable trigger, then push the thumb switch on top of the
control lever back to raise the Riser Boom.
• Depress forward to lower the the Riser Boom
45-AJ Diesel
Operati
ng Instructions & Pre-Operation Function Tests
94533r1
–
December
2017
Page
31
Auxiliary Power System & Test
If primary power fails while the platform is elevated, use the Auxiliary Power System to safely lower the
platform.
Do not climb down the boom assembly or exit the platform while elevated.
ALWAYS check over, under and around the machine for personnel, structures and obstructions before
activating any control function and continue to watch for hazards while operating the machine
Platform Controls
Upper Auxiliary
Power Switch
