MDV M0BA30-11CFN1-MQ0W, Техническое руководство

Страница: 65 / 72

Installation
 Page 65 
use the cable clamp to fasten the signal cable to the unit.
Screw the cable clamp down tightly.
9. Replace the wire cover on the front of the unit, and the
plastic panel on the back.
NOTE:
• Choose the right cable size
The size of the power supply cable, signal cable, fuse, and
switch needed is determined by the maximum current
of the unit. The maximum current is indicated on the
nameplate located on the side panel of the unit. Refer to
this nameplate to choose the right cable, fuse, or switch.
• Take note of fuse specifications
The air conditioner’s circuit board (PCB) is designed with a
fuse to provide overcurrent protection. The specifications
of the fuse are printed on the circuit board, such as:
T3.15A/250VAC, T5A/250VAC, etc.
• Pay attention to live wire
While crimping wires, make sure you clearly distinguish the
Live (“L”) Wire from other wires.
• All wiring must performed strictly in accordance with
the wiring diagram located on the back of the indoor
units front panel.
• Do not mix up live and null wires.
This is dangerous, and can cause the air conditioning unit
to malfunction.
• The wiring connection process may differ slightly
between units.
3.7 Wrap piping and cables
Before passing the piping, drain hose, and the signal cable
through the wall hole, you must bundle them together to
save space, protect them, and insulate them.
1. Bundle the drain hose, refrigerant pipes, and signal
cable according tothe picture below:
Indoor Unit
Space behind unit
Refrigerant piping
Drain hose
Signal wire
Insulation tape
2. Using adhesive vinyl tape, attach the drain hose to the
underside of the refrigerant pipes.
3. Using insulation tape, wrap the signal wire, refrigerant
pipes, and drain hose tightly together. Double-check that
all items are bundled in accordance with the picture above.
NOTE:
• Drain hose must be on bottom
Make sure that the drain hose is at the bottom of the
bundle. Putting the drain hose at the top of the bundle
can cause the drain pan to overflow, which can lead to fire
or water damage.
• Do not intertwine signal cable with other wires
While bundling these items together, do not intertwine or
cross the signal cable with any other wiring
• Do not wrap ends of piping
When wrapping the bundle, keep the ends of the piping
unwrapped. You need to access them to test for leaks at
the end of the installation process.
3.8 Mount indoor unit
3.8.1 If you installed new connective piping to
the outdoor unit, do the following:
1. If you have already passed the refrigerant piping
through the hole in the wall, proceed to
Prepare
refrigerant piping.
2. Otherwise, double-check that the ends of the refrigerant
pipes are sealed to prevent dirt or foreign materials from
entering the pipes.
3. Slowly pass the wrapped bundle of refrigerant pipes,
drain hose, and signal wire through the hole in the wall.
4. Hook the top of the indoor unit on the upper hook of
the mounting plate.
5. Check that unit is hooked firmly on mounting by
applying slight pressure to the left and right-hand sides of
the unit. The unit should not jiggle or shift.
6. Using even pressure, push down on the bottom half of
the unit. Keep pushing down until the unit snaps onto the
hooks along the bottom of the mounting plate.
7. Again, check that the unit is firmly mounted by applying
slight pressure to the left and the right-hand sides of the
unit.
3.8.2 If refrigerant piping is already embedded
in the wall, do the following:
1. Hook the top of the indoor unit on the upper hook of
the mounting plate.
2. Use the holder in the mounting plate to prop up the
unit, giving you enough room to connect the refrigerant