MD MD-AWD-150, Руководство пользователя

Страница: 25 / 49

Mustang Dynamometer MD-AWD-150 Page 25
Fig 4.5 Fig 4.6
Now remove the hardware from the bearings for the sprocket shaft
 
NOTE
When removing the bearings hardware pay attention to any
shims that may be under the bearings… these shims need
to go back in the exact same position when replacing the
sprocket shaft for alignment purposes.
Using figure 4.7 as a guide loosen only two of the bearing adjustment blocks, this will
insure proper alignment and belt tension if you only loosen the two indicated with the
red arrows.
Fig 4.7
Remove the sprocket shaft and place the belt around it… Then replace the sprocket
shaft keeping the shims in the same position
Replace bearing hardware and tighten finger tight.
Tighten the bearing block adjustment bolts so that the bearing slides over and makes
contact with the opposite side bearing block bolts (the 2 that you didn’t move)… tighten
the jam nut on the bearing block adjustment bolts.
Tighten bearing hardware and torque to 50 ft-lbs.