MCZ Forma Series, Инструкция по установке и эксплуатации

Страница: 26 / 33

INSTALLATION AND USE MANUAL
Chapter 5
page
26
Operation Technical service – MCZ GROUP S.p.A. all rights reserved - Reproduction prohibited

Slowly fill the fireplace stove and the system only using
the open expansion tank (if included) through the natural
fall of water;
 With the installation with the tank closed, fill the system
directly from the mains, setting a pressure, when cold, of
1-1.5 bars and discharging any air bubbles in the boiler
and on the system.

Never light the fire if the system is not full of water; the
structure may be damaged.
 While filling, open all the vents of the radiators and those
of the system; vent the air in the system that may
obstruct the circulation of water.

On the control panel or control unit set the start
temperature of the pump (see the instructions of the
control panel).
 Place wood in small pieces that is well dried (humidity
15/20%). Light the fire without excessively overheating
the structure during the first lighting. Any odours from
manufacturing residue and/or evaporation will form the
first time lighting occurs, and will disappear after a
lighting at full power has occurred a few times.
Make sure you have read and completely understood the contents of
this instruction booklet.
Remove any components which might burn from the fireplace stove and
door (various instructions and adhesive labels).
Remove the stickers from the ceramic glass or the high temperature
could melt them and irreparably damage the glass. In this case, the
MCZ warranty does not cover the glass.
The HYDROTHERM fireplace stove can be placed in a corner or along a
wall. You can customize with MCZ claddings or install them during
construction with materials that are resistant to high temperatures.
THE CLADDING MAY ONLY BE INSTALLED AFTER
HYDRAULICALLY AND ELECTRICALLY CONNECTING
THE FIREPLACE STOVE AND HAVING TESTED ITS
FUNCTION AND HYDRAULIC SEAL
The fireplace stove and the parts of the cladding must be attached to
one another without coming into contact with the steel structure
to prevent transmission of the heat to the marble and/or stone, and to
allow normal thermal dilation. Use care with wood finishes such as
crossbeams or shelves.
It is advisable to create the hood of the cladding with plasterboard
panels. It is worthwhile to provide for an airtight inspection grille to
access the probe in case of malfunction.